OMRON G6K-2P-RF DC4.5 is listed in the manufacturer ordering table with a 4.5 VDC coil, DPDT (2c) contacts, single-side stable operation and through-hole PCB terminals. Review the load and PCB requirements before ordering.
Manufacturer source reviewed Request this exact modelG6K-2P-RF DC4.5 specifications
Use these specifications to identify your BOM line. MZZ confirms availability, quantity and delivery against your purchasing requirement.
- Nominal coil
- 4.5 VDC
- Contact arrangement
- DPDT (2c)
- Relay function
- single-side stable
- Terminals
- through-hole PCB
- Enclosure
- fully sealed
- Coil resistance
- 194 ohm; 23 C coil temperature; rated current and resistance tolerance +/-10%
- Rated coil current
- 23.2 mA at rated coil voltage; 23 C coil temperature; rated current and resistance tolerance +/-10%
- Resistive contact rating
- 0.3 A at 125 VAC; 1 A at 30 VDC
- Maximum switching current
- 1 A; apply the manufacturer's voltage/load curve
- Rated carry current
- 1 A; carrying current is not the switching rating
- Operating ambient
- -40 to 70 C; no icing or condensation
- RF rated load
- 1 W at 1 GHz, load VSWR <=1.2
- RF measurement conditions
- Initial values in a 50-ohm measurement system; actual PCB affects RF performance.
- Body height
- 5.5 mm maximum; check the original drawing and land pattern
Why the complete code matters
G6K-2P-RF identifies the single-side stable through-hole PCB version; DC4.5 fixes the rated coil voltage. Preserve Y, T1, RF and packaging suffixes where specified. Confirm polarity/drive timing for latching versions and use the exact PCB drawing. Rated carry current must not be substituted for switching capability.
Where the G6K-RF family may fit
These are family-level screening examples. Final suitability depends on the exact load, environment, required life and approvals.
- RF test and communications signal routing after checking the frequency-specific insertion loss and isolation
- 50-ohm circuit screening using the specified PCB land pattern and actual test fixture
- BOM identification for the exact RF, RF-S, RF-T or RF-V branch
What MZZ verifies before quoting
The original BOM code remains unchanged while commercial and technical conditions are checked.
- Full manufacturer ordering code and every suffix
- Coil voltage, polarity and switching or latching drive
- Contact arrangement, switching load and electrical-life requirement
- PCB terminals, land pattern, enclosure and packing format
- Required quantity, destination, target date and documentation
Manufacturer source
The linked manufacturer record controls technical selection. MZZ rechecks the current source and actual supply conditions after receiving the required quantity and destination.
Need G6K-2P-RF DC4.5 or another G6K-RF variant?